Goods to be aware of:
1. Please provide complete model parameters when placing an order
Including resistance and error, B value, external dimensions, wire length, and operating temperature range.
If the parameters are not determined, please provide the following data
1) Purpose
2) Environmental conditions for use
3) Temperature measurement and control range
4) External dimensions
5) Test power
6) Zero power resistance values and their errors at two or more temperature points of concern
3. Protective sleeves can be added according to customer requirements
Can process connection terminals according to customer requirements
It can be made into high dissipation products, and the testing current can be significantly higher than that of traditional structured sensors, simplifying the circuit.
Can be manufactured according to customer specific requirements (parameters, appearance).
Notes:
1. Thermistors and their temperature sensors should be avoided as much as possible in environments with rapid temperature changes to prevent aging.
2. The current flowing through the thermistor and its temperature sensor can cause the component to generate heat and generate a temperature difference, so please consider this factor before selecting. (When the heating value of the component itself is 1/10 of the dissipation coefficient δ (mW/℃), the temperature difference is 0.1 ℃, and when it is 1/100 of δ, the temperature difference is 0.01 ℃.)
3. Due to poor insulation, electrostatic induction, and incorrect wiring in the use of electric furnaces, excessive current flowing through thermistors and temperature sensors can cause damage. It is necessary to pay attention to the connection method and avoid excessive current flowing through thermistors or temperature sensors.
4. After 5S (second), the sensitive word should be measured again for more than 7S (second).
5. When the usage environment requires rapid measurement and high accuracy, the specification model with small volume and small time constant should be selected.
6. If there are water droplets, dust, or ionic compounds generated by condensation between the leads or on the surface of the insulator, it will cause a decrease or instability in its resistance value, resulting in measurement errors. Therefore, moisture-proof and insulation treatment should be carried out to keep it dry.
Website Navigation:
Contact person: Miss Li
Mobile number: 13924669192
Phone: 0755-86092836 86094645
Fax: 0755-86092848
Website: korneliadengel.com
Email: szshay@korneliadengel.com
Address: No. 8 Xiangxing Road, Buchong Community, Shajing Street, Bao'an District, Shenzhen
Hunan Xinshangying Electronic Technology Co., Ltd
Phone: 0730-2951782
Fax: 0730-2951780
Website: korneliadengel.com
Email: szshay@korneliadengel.com
Factory address: Shangying Industrial Park, No. 8 Changhu Road, Chenglingji Xingang District, Yueyang City, Hunan Province